Isolate the Supply
The gas gets shut off at the meter or the appliance isolation point before anyone starts looking, so the house stops filling while we work out what gave way next.
Gas Leaks Gordon Park
A gas smell is the one plumbing job that starts at the front door. Gordon Park Plumber sends licensed gasfitters to homes across Gordon Park, and you get a fixed quote before any work starts.
If we're late, $100 comes off your bill
- $0 Call-Out FeesNo extra charge for nights, weekends or public holidays
- Available 24/77 days a week, and same-day where we can
- Lifetime Labour WarrantyBacked by our Fix-It-or-It's-Free guarantee (T&Cs apply)
- Licensed and InsuredEvery job done by a licensed plumber. QBCC No: 15024607
Leave First, Then Call
Nothing on this page comes before getting people clear of the house, so read this part first:
Get everyone out
People and pets first, and leave doors open behind you if that does not slow the exit.
Ring us from outside
Call (07) 3524 7117 from the street or a neighbour's place, well clear of the smell.
Leave switches alone
Lights, fans, power points and anything with a flame stay untouched, because one spark near concentrated gas is enough.
Never hunt for the leak
No matches, no lighters, no spray bottles. Once you are out, the tracing is our job, not yours.
What a Gas Leak Feels Like
That rotten-egg smell is an odourant the supplier puts into the gas on purpose, so a fault has a smell at all. It can come and go with the breeze through an open window.
Sometimes there is no smell, just hissing near a heater, a cooktop running yellow rather than blue, or plants dying along a pipe run. Any of those signs earns a professional check.
Likely Causes, Small to Serious
Gas faults range from a five-minute connector swap to a line that needs replacing, and the small ones turn up far more often:
A worn appliance connection
The flexible connector behind a cooker or a wall heater perishes with age, and it is the most common leak we find.
A tired bayonet point
Older heaters on bayonet fittings wear at the socket, especially fittings that have carried heaters for decades.
A corroded joint on an old line
Galvanised and early copper gas runs under interwar houses corrode at the joints, the same way the water lines do.
A fault inside the appliance
Burners, valves and pilots on ageing heaters and cooktops can leak internally, which is an appliance repair rather than a line fault.
Damage after digging or renovating
A line nicked during landscaping, a slab repair or a DIY weekend job can leak where nobody thought to check.
What You Can Safely Check
Very little, and that is deliberate. There is no safe DIY version of a gas job, so the right move is to hand the whole thing over the moment you are outside.
You can note where the smell is strongest, whether it worsens when a particular appliance runs, and whether the meter dial keeps moving with everything switched off. Tell us those three things on the phone and they genuinely help.
When to Ring Us
Call (07) 3524 7117 straight away if the smell is indoors or near the meter, if a heater smells at start-up, or if cooktop flames have changed colour. A smell that fades and returns is still a call, not a false alarm.
For booked work rather than a live smell, installs, appliance swaps and disconnections sit on our gas fitting page.
Gas Lines Under the Old Estate
Most of the housing here dates from between the wars, and the gas fittings have been ageing in place ever since.
Raised houses, low lines
A gas run under a timber house up on stumps shares the damp undercroft with the water pipes, and corrosion does not pick favourites between them.
Bayonet points with decades on them
Wall heaters fitted when the 1920s subdivisions off Beaconsfield Terrace were young have had generations of use on the same brass sockets, and the seals perish quietly.
Unit blocks with history
Census figures put units and apartments at 32.9 percent of homes here, and those cooktop connections near the Khartoum Street shops have been moved, extended and patched for years.
What We Do On a Gas Call
Here is what actually happens once the household is out and we are on site, from shutting the supply down to certifying the repair at the end:
Pressure-Test the Line
A pressure test on the full run tells us whether the fault sits in the line, the appliance or a single fitting, and that sets the size of the job.
Repair the Fault
A perished connector, corroded joint or worn bayonet socket gets replaced with compliant fittings, and a line past its life gets rerun properly where it sits rather than patched again.
Test and Certify
The repaired line gets tested again, the appliance gets checked for safe burning, and the gas work paperwork is completed on the spot for you before we pack up.
Need a plumber in Gordon Park?
$0 call-out fees, available 24/7, and same-day where we can.
Common Gas Faults We See
Four calls make up most of our gas work here, and each one has a pattern we recognise on the phone:
Yellow Cooktop Flames
A burner running yellow rather than its proper blue means incomplete combustion, a blocked jet or an air intake fault, and it is worth sorting before it becomes a carbon monoxide worry.
Heater Smells on Start-Up
Older wall heaters leak at isolation valves and flexible connectors as the seals perish, and a service before winter usually catches them while the fix is still a small one.
Smell Rising Through Floors
A rusted fitting on an ageing gas line beneath a raised house can vent into the undercroft, and the smell often drifts up through the floorboards before it shows anywhere else.
Meter Dial Creeping
A dial that keeps on turning with every appliance shut down means gas is escaping somewhere on your line, and that one is a shut-it-off-and-test call, not a wait-and-see call.
Why It Matters
With gas, leaving a suspected fault alone for a week has a real chance of ending badly, so the case for acting early is not sales talk:
Faults grow overnight
A perishing connector lets gas into a closed house while everyone sleeps. The bill for a fix is always smaller before the fault grows.
Compliance protects you
Gas work in Queensland legally needs a licensed gasfitter and proper certification. That paperwork matters at sale time, and it matters more every day in between.
Older suburbs carry older fittings
A gasfitter who knows the interwar cottages here still run original heater points starts the diagnosis in the right spot, which saves you a visit.
Our Process for Gas Calls
- 1
Give us a call
Ring (07) 3524 7117 and let us know what's going on in Gordon Park. A few questions up front mean we turn up with the right parts.
- 2
The price, before any work
You get flat-rate pricing and no hidden fees before anything is touched. Approve it and we get started.
- 3
Pin the fault first
We shut the gas off at the meter, pressure-test the run to pin the fault, and quote the repair or replacement from what the test shows rather than a guess.
- 4
Easy payment
Pay by card or EFTPOS on site at the end, or ask about Fix now, pay later.
Why Choose Gordon Park Plumber
Every gas job closes with a tested line and a certificate in your hand, whatever the fault turned out to be.
- $0
- Call-Out Fees
- 24/7
- Available, 7 Days
- 200+
- Five-Star Google Reviews
$0 Call-Out Fees, Any Hour
Every job in Gordon Park comes with $0 call-out fees, and there's no extra charge for nights, weekends or public holidays.
Fix It or It's Free
Our Fix-It-or-It's-Free guarantee stands behind the work (T&Cs apply), and if we're late, $100 comes off your bill.
Lifetime Labour Warranty
Every job is done by a licensed plumber under QBCC No: 15024607, and our labour carries a lifetime labour warranty.
Licensed and Insured
A locally owned and operated business, licensed and insured, with flat-rate pricing.
Get a Gasfitter to Gordon Park
Call (07) 3524 7117 with what's going on. We're available 24/7 across Gordon Park, with no call-out fees, flat-rate pricing and work done under QBCC No: 15024607, same-day where we can.
Water going wrong instead? Our emergency plumbing page covers burst pipes and overflowing toilets as well.
Gas Leak Questions Answered
Call (07) 3524 7117What should I do first if I smell gas in my Gordon Park home?
Get everyone outside straight away and ring (07) 3524 7117 from the street, because switches, flames and phones can all ignite gas indoors, then leave the tracing to us rather than hunting for it.
Who is legally allowed to repair a gas leak in Queensland?
Only a licensed gasfitter may touch gas lines, fittings or appliances, and ours work under QBCC No: 15024607, which covers the gasfitting class, with the paperwork to match on every job.
Does Urban Utilities look after the gas pipes at my Gordon Park place?
No, Urban Utilities looks after water and sewer mains, while the gas line and every fitting on your side of the meter belong to you and are yours to maintain as the property owner.
Are the older timber houses in Gordon Park more prone to gas faults?
They can be, because original bayonet points and heater connections in interwar homes have had decades of corrosion and movement working on them, so the fittings perish first, well before the line itself does.
Can I check for a gas leak myself with a flame or spray bottle?
Never take a flame near a suspected leak, and leave the testing to us as the licensed gasfitters on the job, who pressure-test the line once the household is safely outside.
How do I book a gasfitter in Gordon Park?
Call (07) 3524 7117 from a safe spot outdoors, describe the smell and where it is strongest, and we will lock in the visit and put the price in writing before work begins.
